The power cord is covered with an insulated braided sheath, which does not generate heat during charging. This sata cable connects the motherboard and host controller to the internal serial ata hard drive and dvd drive, quickly upgrading your computer for expanded storage, reduce the risk of damaging the drive or the motherboard sata connector.
The ide 4p to sata 15p data cable supports hot-plugging, no driver installation, 26 awg power extension cable with multi-voltage compatibility, widely compatible with sata, hard disk, optical drive, ssd, pci-e card and other devices with sata. The sata iii 6 gbps fast data transfer, 2 times faster than sata ii, provides excellent performance for custom games or raid configurations; provides a secure connection for fast and reliable file transfer. The sata data power 2-in-1 cable can both power and high speed transmission.
Supports full sata 3. Add three extra sata power outlets to your power supply sata to sata power cable sata power splitter cable serial ata power splitter Sata power splitter cable adapter 1x sata power plug to 4x sata power receptacle. This 18" internal SATA cable is certified for 1. While parallel data transfers are theoretically faster than serial transfers the older parallel ata pata was limited to a maximum data transfer rate of mbps As an added bonus the smaller connectors and thinner cables made it far easier to route and connect cables within a computer case turning.
Secure connection: locking latch on each end of the cable to ensure secure connections for fast and reliable file transfer. What you get: usb ugreen sata 3 cable 18inch 3pcs in one package x3, and lifetime friendly customer service. Ugreen sata 3 cable is designed to connect motherboards and host controllers to internal serial ata hard drives and dvd drives, quickly upgrading your computer for expanded storage.
Keep the drive in the protective anti-static container until you are ready to install it to minimize handling damage. Drive electronics are extremely sensitive to static electricity. While installing the drive, wear a wrist strap and cable connected to ground. Turn off the power to the host system during installation.
Do not disassemble the drive. Doing so voids the warranty. Do not apply pressure or attach labels to the circuit board or to the top of the drive. Attaching Cables and Mounting the Drive Attach one end of the drive interface cable to the Serial ATA interface connector on your computer's motherboard or Serial ATA host adapter see your computer manual for connector locations.
Host adapter configuration is shown below. Serial ATA connectors are keyed to ensure correct orientation. Attach the interface and power cables to the drive. Secure the drive using four UNC mounting screws in either the side-mounting or bottom-mounting holes.
Insert the screws no more than 0. Do not overtighten the screws or use metric screws. This may damage the drive. Restart your computer. Within the system setup program, instruct the system to auto detect your new drive.
Save the settings and exit the setup program. When your computer restarts, it should recognize your new drive. If your system still doesn't recognize your new drive, see the troubleshooting section. Serial ATA is a new interface type. Final Thoughts: With the growing DIY market first time system builders may look over the little details that make a system rock solid. The difference is obvious and in closing let me leave you with this image: Which do you want plugged into your hard drive?
Previous Page.
0コメント